UTEC Merged With Innovate LC-1 Wideband and Jeff's UTI 3 Software.

I have a UTEC and an Innovate LC-1 wideband with a DB9 gauge. Until today they were seperate and was unable to log A/F data to UTEC for data logging my runs. My buddy QuadCam hooked it up for me today so I can datalog using Jeff's Software http://www.jeffsoftware.com/ UTI3 program which also has a dashboard that allows you to read engine paramaters such as coolant temps, air inlet after intercooler temp, ambient air temp, RPM, throttle position sensor, boost presure/vacuum, injector duty cycle and a few others, but those are the big ones. So by hooking up the LC-1 to the laptop the UTI3 program will datalog it as well as everything else. The LC-1 wideband controller comes with the serial cable you need but most laptops will require a serial to USB converter cable. Once both cables are pluged into the laptop via USB open the software and read in real time all the parameters on the dashboard. Use your computers s-video out and run a cable to a dash mounted monitor as a display while driving. For something permanent get a permanently mounted carputer.

Check out all the features of the UTI3 software on Jeff's website. It's a real bargain for $24.95. You'd have to be an r-tard to not have this valuable tool. Good Stuff!


Jeff's Software UTI 3 Dashboard Display